Monster Helmet

• Keep away from heat and open flame, including candles, fireplaces, stoves, heaters and hot cars. PLA can soften and warp at around 55°C (130°F).
• Not dishwasher, microwave or oven safe. Wipe clean or hand wash in lukewarm water and dry completely.
• Store in a cool, dry place out of direct sunlight.

• This is a decorative item, not a toy. It contains small parts and is not suitable for children under 3. Adult supervision is recommended.
• Not edible, and not intended for contact with food.

• All pieces are rigid. Pieces inspired by squishy toys are not soft or squeezable.
• A fine layered texture is a natural part of 3D printing, not a flaw.
• Colours may vary slightly from screen to screen and between batches.
• Sizes are approximate, and small variations make each piece one of a kind.
• Elf costumes are designed to fit [most standard shelf elves]. The elf is not included.

Sweets By Design is not affiliated with or endorsed by The Elf on the Shelf® or any toy brand. Costumes are original designs sold separately for use with your own figure.

 

Sizes measured are Length x Width x Height